How to Pair a Superlink to a J-150 or J-70 Controller

1. Confirm the controller is already paired to the drone 0:10

• Start on the controller and confirm it shows System Ready.
• This indicates the controller is already paired to the drone and is ready for the Superlink setup.
• Next, navigate to the Device page to begin the Superlink pairing process.

2. Open the RTK Station page on the controller 0:17

• On the left side of the Device page, scroll until you find RTK Station.
• Select RTK Station to access the pairing options for the Superlink.
• Keep this page open while you power on the Superlink.

3. Power on the Superlink 0:37

• Locate the Superlink device.
• It should be off at first.
• Long press the power button to turn it on.
• Once the LEDs begin to light up, short press the power button again if needed to fully start it.

4. Wait for the Superlink LEDs to indicate readiness 1:06

• Pay attention to the three LEDs on the Superlink:
  • Drone
  • RC
  • Satellite
• At first, the RC light may show red, which means the Superlink is still starting up.
• Wait until the RC, drone, and satellite LEDs are flashing green before continuing.

5. Put the Superlink into pairing mode 1:39

• Once all required LEDs are flashing green, long press the power button on the left side of the Superlink.
• The RC LED should change to flashing green and red, which confirms the Superlink is now in pairing mode.

6. Start pairing from the controller 2:02

• Return to the controller’s RTK Station page.
• Tap the Connect button on the right side of the screen.
• When prompted, select Confirm to begin pairing.
• The controller’s pairing indicator should start flashing green and red.

7. Wait for the controller and Superlink to connect 2:16

• Allow the controller time to search and pair.
• Pairing can take 1 to 5 minutes.
• If successful, the controller will connect to the Superlink automatically.

8. Use Fast Align if pairing does not complete 2:38

• If the controller does not pair right away, tap Fast Align at the bottom of the screen.
• This forces the controller to cycle through the pairing frequencies again.
• Confirm the prompt if asked, then wait for another pairing attempt.

9. Verify the connection was successful 3:25

• Once paired, the device serial number will appear on the right side of the screen.
• You should also see an activation status at the bottom of the Device page.
• These indicators confirm the Superlink is connected to the controller.

10. Set the Superlink to base station mode 3:37

• The Superlink is currently set to base mode, so you need to enable it for use.
• On the same Device page, scroll up to the Base Station section.
• Select J-Link.
• This enables the Superlink to act as a base station so you can continue flying with it connected.