Installing T50 Front Sprinkler Kit

Tools needed: T-handle or Impact w/allen key, two and a half, and three millimeter, channel locks.

1. Initial Steps

   • Remove the foam motor cover to expose the area.

   • Disconnect the arm position sensor.

   • Open front covers to access internal components.

2. Disconnecting Components

   • Disconnect cables and feed them outside.

   • Remove rubber boot from the arm connector.

   • Disconnect ESCs by unscrewing and pulling them out.

3. Installing New Arm Cables

   • Remove imposition sensor from the other arm.

   • Reinstall the sensor on the new arm cable.

   • Slide the new arm cables through the arms carefully.

4. Finalizing Installation

   • Ensure correct positioning of cables and plugs.

   • Plug in ESCs and secure them with screws.

   • Run arm hoses through the arms, avoiding kinking.

   • Fold the arm out to feed hoses through completely.

5. Completion

   • Ensure all components are securely in place.

   • Double-check connections and cables.

   • Finish the installation process without damaging any components.