J100 How to replace the Flow Meter

Here is a detailed step-by-step guide along with an accompanying video.

Video

Step 1: Remove Hex Head Screws 0:00

• Use a 2.5mm Allen screwdriver.

• Carefully remove the hex head screws.

Step 2: Loosen Hose Nuts 0:21

• Loosen all four hose nuts.

• If too tight, use channel locks for assistance.

Step 3: Remove Hoses 0:45

• Carefully pop off all hoses.

• Be cautious when removing screws from the flow meter.

Step 4: Understand Screw Threads and Gaskets 1:01

• Note that screws thread through into the tank.

• Ensure small rubber gaskets are present on the back of the flow meter.

Step 5: Prepare to Reattach Screws 1:14

• Insert screws through the flow meter with washers on the front side.

Step 6: Secure Screws with Rubber Washers 1:25

• Place rubber washers on the backside of the screws to hold them in place.

Step 7: Unplug from the Tank 1:37

• Unplug the flow meter from the tank.

• Optionally, remove the tank for easier access.

Step 8: Reverse the Process 1:45

• Reattach all screws to the new flow meter.

• Ensure to use washers as previously described.

Step 9: Reattach Hoses and Plug In 2:04

• Screw the new flow meter into place.

• Reattach all hoses and plug the flow meter back in.

Step 10: Contact for Further Questions 2:15

• If you have any further questions, reach out to your local dealer.

Click here to go to store for a new J100 Ultrasonic flowmeter