This article outlines the step-by-step process for replacing the weight sensor module on a J100 to ensure proper installation and calibration. Errors (26-024),(26-025),(26-026),(26-027) (27-032),(27-033),(27-034),(27-035)
Key Steps
1. Remove the Weight Sensor Module 0:14
-
Locate the weight sensor module on the J100.
-
Use a 2.5mm hex bit to remove the four screws securing the sensor to the frame.
-
Carefully pull the sensor away from the frame.
2. Disconnect the Signal Cable 0:49
-
Push the cable connector into the module to relieve tension on the tabs.
-
Press the release button on the connector while pulling it out to disconnect the signal cable.
3. Install the New Weight Sensor Module 1:23
-
Take the new weight sensor module and connect the signal cable using a push and pull method to ensure a secure fit.
-
Ensure the retaining clip clicks into place.
Click Here for J100 weight sensor
Click Here for J100 weight sensor cables
4. Secure the New Sensor Module 1:46
-
Align the new sensor module with the frame and start the screws.
-
Tighten the screws until they stop spinning, then gently tap with a hammer to secure (do not overtighten).
5. Reinstall the Tank 2:24
-
Reinstall the tank onto the J100, ensuring it is seated on all pegs of the weight sensors.
6. Power On and Calibrate the System 3:08
-
Connect the drone to power and allow it to boot up.
-
Access the settings to perform weight calibration.
7. Perform Weight Calibration 4:07
-
Follow the on-screen prompts to lift the tank off the drone and reset the weight.
-
After the countdown, place the tank back on the drone and start the tear calibration.
8. Verify Calibration Completion 4:49
-
Ensure the calibration process completes successfully and check that everything is functioning properly.
Click here for video on J100 Weight Calibration
Cautionary Notes
-
Avoid overtightening screws as this can damage the plastic components.
-
Ensure all connections are secure to prevent sensor malfunctions.
Tips for Efficiency
-
Use a magnetic screwdriver to prevent losing screws during removal and installation.
-
Keep the workspace organized to easily find tools and components during the process.
Stay Informed: Subscribe to the Agri Spray Drones Newsletter
How to Subscribe
Subscribing is easy and takes less than a minute:
-
Visit Our Website
Go to www.agrispraydrones.com -
Scroll to the Bottom of the Homepage
Look for the “Subscribe to Our Newsletter” section. -
Enter Your Email Address
Type in the email address where you'd like to receive updates. -
Click “Subscribe”
Once you submit, you’ll be added to our mailing list and will start receiving valuable updates straight to your inbox.
Don’t Miss Out
Join thousands of ag professionals who trust Agri Spray Drones for the latest in drone spraying and precision ag.
Subscribe today — and let us help you take your operation to the next level.