J100 - How to select a flow rate and micron size for full manual spraying

Guide to Operating

1. Access Spray Settings 0:01

• Locate the spray settings on your drone interface.

• Choose to turn on the spray system for ground or manual aerial spraying.

2. Set Flow Rate 0:17

• Select 'fixed flow rate'.

• Choose your desired flow rate (e.g., 2.6 gallons per minute).

3. Choose Droplet Size 0:30

• Select the droplet size you wish to use.

• Ensure the correct disc is selected, as it affects droplet size.

4. Activate Spray Control 0:30

• Turn on the spray control to begin spraying.

• The drone will spray at the selected RPM, droplet size, and flow rate.

5. Change Droplet Size (if needed) 0:48

• If you change the droplet size, remember:

  • The change will not take effect until you hit 'spray on'.

6. Return to Auto Mode 1:02

• After completing your spraying, select 'auto' mode.

• This prevents the spray system from activating in no spray zones.