How to link Superlink to J100

A quick guide to connecting your EA Vision Superlink to your EA Vision J100.

1. Preparation

• Ensure the drone and remote are turned on and linked together.

2. Turning on the Superlink

• Activation Method:

  • EA Vision Superlink: Short press followed by a long press.

  • Other EA Vision Products: Long press followed by a short press.

• Status Indicators:

  • Status lights flashing green indicate initialization.

  • Drone and RC lights initially flash red; RC light will then flash blue when ready for connection.

3. Linking the Superlink

• Navigate to the remote control settings:

  • Go to Device > RTK Station (necessary even if using Superlink as a relay).

• Connection Process:

  • Hit the Connect button on the remote and confirm.

  • Long press the power button until the RC light flashes red and blue.

• Waiting Period:

  • Pairing may take up to five minutes; monitor the lights for confirmation.

4. Confirming Connection

• Indicators of successful connection:

  • RC light turns solid blue.

  • UAV drone light turns blue.

• Display information:

  • Serial number, firmware version, longitude, latitude, battery percentage, and device temperature.

5. Managing RTK Settings

• Current Status: RTK disconnected (operating as a relay).

• To set Superlink as an RTK base station:

  • Click on Disconnect, select Superlink from the dropdown.

• To turn off the base station after use:

  • Short press, then long press the power button.

6. Disconnecting from Relay

• Navigate to Settings > Flight Settings:

  • Select Remote Control directly connected to the airplane.

  • Confirm to disconnect from the relay.

• Importance of this step:

  • Ensures the remote and drone can communicate after the relay is turned off.

• Emergency Procedure:

  • If the relay fails in flight, use this method to regain control of the drone.