Tutorials
      Back to home
      1. ASD Knowledge Hub
      2. HD408 Auto Steering System
      3. Tutorials

      Settings to Change Before Calibration - HD408 Autosteer

      Consider changing these settings prior to Quick Calibration

      • Switch to Imperial units
      • Enable Manual Steering override

      1. Access System Settings 0:01
      • Start by navigating to the settings menu.
      • Locate the settings icon in the bottom left-hand corner of the screen.

      2. Change Measurement Units 0:08
      • Go to 'System' and then select 'System Configuration'.
      • Change the measurement units to 'Imperial' to ensure correct measurement inputs during calibration.

      3. Adjust Additional Settings (Optional) 0:24
      • In the same menu, you can also:
        • Enable voice broadcast for audio feedback.
        • Activate the U-turn display feature if desired.

      4. Save Changes 0:41
      • After making your changes, press 'OK' to save.

      5. Access Advanced Calibration 0:55
      • Navigate back to the main menu and select 'Advanced Calibration'.

      6. Enable Manual Steering Override 1:11
      • Scroll down to find 'Manual Steering Override'.
      • Turn this feature 'On' to allow manual control of the steering wheel while in auto steer.
      • Set the value between 1 and 4 for quick override response.
        • A higher value will require more force to override the system while Autosteering is active 

        7. Finalize Settings 1:20

      • Press the green check mark to save your settings.